AW: "gndloops"

[jdm at synthcom.com]

At 12:43 PM 4/8/98 +0200, Martin Czech wrote:

>Further: If I set up a system in the proposed way, and I have the
>feeling that problems get worse, I can always change it afterwards:
>simply connect the different grounds on the module pcb via bridges
>instead resistors (in fact, there are "0" Ohm resistors for that purpose
>on the market) and disconnect/high-Ohm-connect the cable shields at one
>side. This is possible. But if you start with a "normal" system, it is
>almost impossible to do it the other way after you have finished it.

Aren't 0 Ohm resistors just jumper wires that are designed for use in
automatic insertion equipment in cases where a resistor was designed in but
proves to be unnecessary?  It would be cheaper for DIYers to just cut a wire
jumper.

JDM


"What happend,,music are no more fun anymore, young kids are
using some speedy drugs and shake their butt for 12 hours 
or more until the butt losses and swing away into 
the wall with splash sound." - BJ in the land of chernobyls 
radio active waste...