MIDI2CV8 Panel for Digisound systems

[Chris Crosskey]

Hi Folks, 
I've done a design for a Panel for the PAIA MIDI2CV8 on a 9x3 inch 
Digisound compatible panel. They are not drilled, but the drilling 
points are marked on them for the mounting screws (assuming the use of 
RS or similar mounting brackets), the MIDI sockets, the activity LED 
and the Channel and Mode switchblock. If you aren't building a Modulus 
system you might prefer to have it done without the Modulus name at 
the bottom of the Panel (in much smaller lettering than the PAIA near 
the top of the Panel incidentally, I only put it there so it'd fit 
with the rest of my stuff), and I can offer it printed in black on a 
white panel for Digisound users, and printed in white on a black panel 
for Modulus users.
	The Panels cost 4.5 UKP each plus postage at cost, and they 
weigh approx 250 grammes each (about 8 oz) as they ae made out of 2mm 
steel....David Peachey and Dave Burraston can probably vouch for their 
strength compared to original Digisound panels. 

chrisc