Cheap PCB Info Request

[Tony Clark]

>      Recently I saw a post to DIY about a cheap PCB house. Yes I deleted 
>      it, darn it, and now I'd like to see it again. The setup fees were 
>      really cheap and I'd like to give it a shot. If it works out then I 
>      might be able to donate some Gerber files to Paul's $35/module 
>      collection!

   That would have been my post probably.  The place is Alberta Printed 
Circuits.  URL is www.apcircuits.com

>      I seem to remember the prices were for top layer/bottom layer, plated 
>      thru holes, no soldermask, so silkscreen. That would be fine for me, 
>      as long as the layers are tinned.

   That is correct.  Yes they reflow solder the whole board once it has 
been etched so you get a nice silvery board.  Looks like it came out of a 
piece of equipment 20 years ago!
   They have a quick turn around time, 2 days!  But remember to take a 
look at their web site as they do have some minor rules your gerber files 
will have to adhere to.
   Good luck!

   Tony

-------------------------------
I can't drive (my Moog) 55!
-------------------------------
Tony Clark -- clark at andrews.edu 
http://www2.andrews.edu/~clark
-------------------------------