best way to cut 1/4" holes in plastic?

Stew Benedict benedict at netcom.com
Tue Oct 22 18:17:30 CEST 1996


There's a nifty conical drill bit available from some of the hobby 
electronics sources that works pretty good for plastics.  It's a stepped
cone configuration - so you can drill a number of hole diameters.  Radio
Shack may even sell it.

Stew

Also, here's the follow-up on the source for MetalPhoto:

Metalphoto Of Cinti Inc...1080 Skillman Dr...Cincinnati, OH 45215-1137
Phone: (513)772-8281

Stew

~~ Stew Benedict  ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~    AYS Enterprises ~~
benedict at netcom.com        http://www.geocities.com/SiliconValley/8608
~~~~~~      "It's not just shy sluggin' gorms neemer!"          ~~~~~~
~~~ Proud sponsor of the plotbot - plots by email!  Send email to  ~~~
~~~~~ benedict at netcom.com, subject "plotbot help" for more info  ~~~~~





More information about the Synth-diy mailing list