Stupid schematic-reading question

[Peter Ullrich]

Hi !

>   The schematics themselves are actually pretty simple, but I've got a
>bit of a problem with the capacitor values.  Some of the values are just
>numbers without values; I'm assuming these are microfarads but I'm not
>sure.

You are on the right way !

>Others are expressed as a number, a slash, and then another number;
>kind of like a fraction, except I don't think the numbers make sense as
>capacitor values.  (e.g. 10/16, 1/50, 47/16, .47/50, 33/6.3)

All these are normally Alu-Electrolythic Capacitors:

10/16  => 10uF / 16 Volts
1/50   =>  1uF / 50 Volts
47/16  => 47uF / 16 Volts
.47/16 => 470nF / 50 Volts
33/6.3 => 33uF / 6.3 Volts

Ciao
Peter

        \|/
       (o o)
--oOOO--(_)--OOOo------------------------------------------------------
                   Ing. Peter Ullrich      mailto: ullrich at kapsch.co.at
                   http://www.geocities.com/SiliconValley/Heights/3586/
                   Hardware & Software Developer /  Electronic Musician
   .oooO           KAPSCH AG / SGB2                    Vienna / Austria
   (   )   Oooo.            Traffic Control and Transmission Technology
----\ (----(   )-------------------------------------------------------
     \_)    ) /
           (_/