rite of passage

[Matt Haines]

>Yup. I have one, and in a past life (like when I was building a lot) I used
>it all the time.
>
>The tool works well, but you'll need a good metal file/Dremel grinder/etc to
>clean up after it. The nibbler leaves little nooks and crannies around the
>sides of the cuts. It's not hard to clean up after, but it is something that
>you have to do. Depending on the gauge of the panel you're cutting, it sure
>beats drilling a bunch of 1/4" holes side-by-side and grinding out all the
>flash.

Will a nibbler work on 1/8" aluminum?

.       .       .       .       .       .       .       .       .
    .       .       .       .       .       .       .       .
.       .       .       .       .       .       .       .       .
Matt Haines  haines at apc.net         .       .       .       .
control-X:to:abort:transmission .       .       .       .       .
    .       .       .       .       .       .       .       .
.       .       .       .       .       .       .       .       .
    .       .       .       .       .       .       .       .
I am not a grotto blaster.