ASM-1 Faceplates for sale (?)

[Aural Research Facilities]

>From: Christopher List <Christopher_List at sonymusic.com>
>I'd really rather not. If you guys want to pay me a little extra, I could
drill 
>holes for you (to spec) on my drill press, but otherwise it just doesn't make 
>sense because some people may want to use 1/4" jacks, some may use different 
>sized pots, etc. For example - the banana jacks I use fit in a different size 
>hole from "normal" jacks beacuse the shaft is metal and it uses a spacer in
the 
>hole to keep it from touching the face plate.

I've had a really good solution for my holes here, in my rack panelling.
For the following units:

- Offshore (cheap! :) ) pots
- Piher 21HE6 Linear or Log pots
- Switchcraft #11 or offshore (cheap again! :) ) 1/4" jacks
- EF Johnson and HH Smith banana jacks

(IE: 95% of all parts that go into my panels)

I punch the hole first.  Then I drill it on the press with a 1/8" drill bit.
Then I redrill every hole on the drill press with a 3/8" drill bit.  In
every case above, I have a perfect fit.

That does solve a LOT of previous problems.  (5mm LEDs and mini-toggle
switches for SPST and up to 4PDT all fit into a 1/4" hole instead).

Hope this helps anyone out there.  Chris?  :)

Take care all,
Ric
                       Aural Research Facilities
        "Building the lowest cost modular synths, in the .... :) "
                           rmiller at pangea.ca
                     http://www.pangea.ca/~rmiller