extending the range above or beyond what a programmble synth normally sees...

[DJMaytag]

this may be getting a bit tweaky here, so let me know if my explanation of
what i'm thinking of here is lacking.

when you go to write a patch into a programmable synth, it scans all the
resistors and switches and anything else relevent to the patch (right?). now
i'm wondering that if were to mod the synth, say to increase or decrease the
resistance of a pot HIGHER or LOWER that what it normally should be, would
that be taken into consideration when you write that patch into memory? or
does it know to only look at a certain range of resistance?

i guess what i'm wondering is if a could somehow decrease the frequency of
an LFO in a synth by changing the resistance of the LFO freq knob on a synth
(probably my p-600).

mitch

djmaytag at terracom.net

three things to remember about me:
1) i'm not a dj
2) i have no intentions of becoming a dj
3) i'm not a washer and dryer repairman either

http://www.washerndryer.net/djmaytag/DJM/
"home of DJMaytag's Bass Tone(TM)"