PNP Blue, also Dril Microscop

[gstopp at fibermux.com]

     Question for y'all:
     
     I use Easytrax, and we have a hot roller laminator here at work. My 
     question is - is there a way I can send my Easyplot layer files to the 
     network laser printer? I did look around for the appropriate driver in 
     my Easytrax files, but didn't see anything appropriate. Perhaps it's 
     because I'm using the DOS version (free download from Protel's web 
     site).
     
     If the freebie FTP download didn't include the printer driver that I 
     need, does somebody have it?
     
     - Gene
     gstopp at fibermux.com


______________________________ Reply Separator _________________________________
Subject: Re: PNP Blue, also Dril Microscop
Author:  "R.G. Keen" <keen at austin.ibm.com> at ccrelayout
Date:    12/12/96 2:02 PM
     
The limitations of Press-N-Peel are about 10mil traces, and a practical 
board size limit of about 6-8 inches in any dimension, because of the 
non-uniform thermal expansion of the plastic substrate material under 
hand ironing. I suspect that one could tinker with a hot-shoe office 
laminating machine and get perfect -* and repeatable *- results over
a full sheet. In fact, with a reliable and adjustable hot roller 
machine, I don't see why one couldn't set up a pc board shop where you 
charged LESS for small quantities, as the most economical quantity to 
manufacture would be one.