<div dir="ltr">Yep, that was it. I had to go back to an npn transistor with a series diode and resistor driving the base (I was hoping the MOSFET would give me a sharper edge on the top of the sawtooth. It's a bit rounded with the npn).</div><br><div class="gmail_quote gmail_quote_container"><div dir="ltr" class="gmail_attr">On Sat, Dec 13, 2025 at 12:41 PM Donald Tillman <<a href="mailto:don@till.com">don@till.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div>On Dec 13, 2025, at 12:06 PM, Scott Bernardi via Synth-diy <<a href="mailto:synth-diy@synth-diy.org" target="_blank">synth-diy@synth-diy.org</a>> wrote:<br><div><blockquote type="cite"><br><div><div dir="ltr">I built a tri core vco and used a typical method to convert the triangle to a saw using the invert - noninvert of the triangle and adding the square back in.  Schematic and the waveforms I get are on this page:<div><a href="https://www.bernacomp.com/elec/og2/weird-saw.html" target="_blank">Weird Saw</a></div><div><br></div><div>Any ideas what's going on and how to correct it?</div></div></div></blockquote><br></div><div>The 2N7000 has a parasitic diode between the drain and the source, so it will start conducting if the drain goes more than 0.6V negative.<br id="m_-7914858390887860015lineBreakAtBeginningOfMessage"><div><div dir="auto"><div dir="auto"><div><br>  -- Don<br>--<br>Donald Tillman, Palo Alto, California<br><a href="https://till.com" target="_blank">https://till.com</a></div></div></div></div></div></div></blockquote></div>