<br><font size=2 face="sans-serif">both the positive and the negative voltages
from the supply go right through a bead (or a 10-20R resistor) to the circuit.
the positive and the negative rails then are connected to ground via the
caps. the ken stone circuits sometimes show caps and/or polarized caps.
</font>
<br>
<br><font size=2 face="sans-serif">you won't necessarily have to decouple
the circuits on the breadboard. i never did yet but i think it would be
a kind of good practice.</font>
<br>
<br><font size=2 face="sans-serif">matthias</font>
<br>
<br><font size=2><tt>owner-synth-diy@dropmix.xs4all.nl wrote on 05/09/2006
07:58:07 AM:<br>
<br>
> hello there again, fellows,<br>
> <br>
> please let me know if i'm asking too many questions.  but!  things
are<br>
> starting to make much sense to me now.<br>
> <br>
> i was curious, though, about the power rail decoupling(s) on some
of<br>
> Ken Stone's modules.  i've also seen this on other schematics
before. <br>
> but, i've never known how to use it.<br>
> <br>
> i understand that power from the power supply comes in, goes through<br>
> two beads, then through two capacitors, then out.  then there
is a<br>
> small diagram to the right.<br>
> <br>
> i guess i'm just unsure how to actually make this on a breadboard.<br>
> <br>
> any tips?<br>
> <br>
> thanks,<br>
> cole groff<br>
> <br>
</tt></font>