<br>
<br><font size=2><tt>"Tim Parkhurst" <tim.parkhurst@gmail.com>
wrote on 05/03/2006 08:58:40 AM:<br>
<br>
> On 5/2/06, Matthias.Herrmann@jeppesen.com<br>
> <Matthias.Herrmann@jeppesen.com> wrote:<br>
> ><br>
> <heavily snipped><br>
> > ><br>
> > > Are you certain that you'll need an HPGL editor?  
 I don't use schaffer's<br>
> > > software, so I'm unsure how their import function works,
BUT:<br>
> ><br>
> > hello dave,<br>
> > importing hpgl-files into a schaffer frontpaneldesign saves a
lot of money!<br>
> > drawing the graphics within the schaffer software would raise
the expense<br>
> > dramaticly!<br>
> ><br>
> <br>
> ??? Are you sure about this??? I would think that the drilling /<br>
> engraving required to create the panel and the graphics would be the<br>
> same, regardless of the method used to create the panel drawing. Any<br>
> comments from those who have used Schaffer panels?<br>
> <br>
</tt></font>
<br><font size=2><tt>yes, i am shure about this. i once had a simple hpgl
editor (which i can't find again) and imported scales for the pots instead
drawing the scales within the schaffersoftware. its much cheaper. try it.
?it was a topic in the list months ago, i think?</tt></font>
<br>
<br><font size=2><tt>> <br>
> Tim (confused, but you've all come to expect that) Servo<br>
> --<br>
> "Imagination is more important than knowledge." - Albert
Einstein<br>
</tt></font>
<br><font size=2><tt>Matthias</tt></font>
<br><font size=2><tt>"don't ask, just be amazed"</tt></font>