[sdiy] M-Audio Midisport Uno Wire to pin ?

[Pete Hartman]

You should be able to determine the output side by hooking a 220R across
the colored wires and scoping the voltage on either side, with reference to
the ground wire...

I mean technically it's just supposed to be a current loop, but in practice
most of the ones I've seen only toggle the pin 5 side.  And ground is
supposed to be used to shield the output side, so the presence of that
shield wire tells you which is in and which is out.

The input side ...   Once I had the output side sussed out, I'd try to loop
it back on itself and see which orientation generated LED activity.

Pete



On Sat, Jan 7, 2023 at 4:19 PM David Messenger <mssngr1 at pacifier.com> wrote:

> I have to rewire the in/out DINs on a Midisport Uno that lost it's midi
> plugs. There is one wire that has red-black-yellow and a bare ground,
> and then the other cable has just red and white. Anyone know which pins
> each of these wires should be reattached to? TY D.
>
>
> --
> This email has been checked for viruses by AVG antivirus software.
> www.avg.com
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20230107/ebd83d51/attachment.htm>