[sdiy] Issue with CD4024 Ripple Counter

Neil Johnson neil.johnson71 at gmail.com
Tue Sep 21 16:04:41 CEST 2021


Hi Dave,

What scope probes are you using?

Cheers
Neil

On Tue, 21 Sept 2021 at 14:41, David G Dixon via Synth-diy
<synth-diy at synth-diy.org> wrote:
>
> So, I built the new circuit (I've attached the schematic again here).  Note that I changed the 100k resistor from the diode to ground to 10k, as this made the simulation results ever so slightly cleaner at the transitions.
>
> Results: MC14024BCP and CD4024BCN are still clocking as they should.  CD4024BE is still clocking on the wrong edge.
>
> I swapped the diode and the 10k resistor just to see if that would have any effect -- it didn't.  Also, I like them the way they are because the keep the levels closer to the opamp output and zero.
>
> I've also attached a scopeshot of the falling edge, taken with the probe attached to the 4024 CLOCK pin.  As you can see, it is just about the cleanest transition you could ever hope to see.  If that edge can't clock a CMOS chip properly, then nothing can.
>
> So, I'm out of ideas.  I could disconnect the 20k resistor to see if the rectifier is affecting the CLOCK pin, but I honestly cannot see how it could, given the very low output impedance of the TL072.  The comparator is more or less completely optimized now, and is performing admirably.
>
> I guess I'll try Tim's simple clocking circuit on breadboard to see if I can get that to work.  However, I'm not holding out much hope, since I think it is fair to say that my comparator circuit is generating what looks to be a more or less perfect clock signal.
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org



More information about the Synth-diy mailing list