[sdiy] Issue with CD4024 Ripple Counter

Magnus Danielson magnus at rubidium.se
Sun Sep 19 22:37:05 CEST 2021


Hi Dave,

On 2021-09-19 21:18, David G Dixon via Synth-diy wrote:
> Well, the plot thickens...
>
> I just went out and dug all the CD4024 out of the trash, cleaned them up and
> tested them all in my spanking new prototype with all the bells and
> whistles.
>
> Here's the result:
>
> CD4024BCN works perfectly (2 chips tested)
>
> CD4024BE does not work (3 chips tested) -- it seems to want to clock on both
> edges, erratically.
>
> I am now willing to concede that there is something in my circuit that is
> preventing the CD4024BE from working -- I just have to hunt down what it is.
> Why the BEs should behave so differently from the BCNs is beyond me -- I
> guess I've got to do a deep dive into the datasheets.

The CD4024B (classic CMOS, buffered) will have their limits for input 
low and input high at about 30% of the power from the line they should 
be, so for 5 V the low needs to be 0-1.5 V and high needs to be 3.5-5 V.

The CD4024BC has improved noise performance, boasting typical 0-2 V and 
3-5 V respectively. Now, the guaranteed values is the same, but the 
highlight in the datasheet suggest improvement.

I would look carefully on the clock transition with a fast enough scope. 
I suggest you use a fast enough transition and provide good enough 
decoupling to deal with the faster transition. Too slow transition 
results in false triggers unless you have good enough supression. Yes, 
the 4024B should have a schmitt trigger, but that is not always the best 
approach to deal with slopes.

As you measure the clock input, make sure there is a small loop area 
between probe tip and probe ground-connection at the chip.

Cheers,
Magnus

>
> Unfortunately, it is the BE chips that are the most widely available in
> through-hole format ($0.31 at Tayda).  I also ordered 100 MC14024 on Ebay,
> as they are now obsolete in through-hole, and therefore no longer available
> via the normal channels.  Gawd I hate this part of electronics.
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org


More information about the Synth-diy mailing list