[sdiy] Two parameter mechanical controller thoughts....

[Pete Hartman]

On Mon, Jun 10, 2019 at 2:54 PM thresholdpeople <
thresholdpeople at protonmail.com> wrote:

>
> And personally I'd use a 10-turn pot over an encoder. The circuitry will
> be far simpler.
>
>
the primary goal is being able to smoothly adjust two parameters at the
same time.  10-turn pots don't really enable that in my experience, quite
the opposite.

If you put it on the pulley, then honestly it's not any better than a
standard pot with appropriate gearing to make a full throw go from CCW to
CW.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20190610/7ca3a8b4/attachment.htm>