[sdiy] Two parameter mechanical controller thoughts....

Pete Hartman pete.hartman at gmail.com
Fri Jun 7 15:55:18 CEST 2019

On Fri, Jun 7, 2019 at 7:07 AM bbob <fluxmonk at gmail.com> wrote:

> i'd go wireless - bluetooth or ble from whatever controls are on the
> carriage, and a time-of-flight sensor to measure the carriage position.
> there's probably a lot of hardware bits you could repurpose from folks
> developing diy 3d printers for the carriage mechanics.
I'm not sure wireless would be practical for within-the-module
communications in a Euro module or standalone controller meant to interface
with Euro.....

3D printer carriages would be a good source of inspiration though.

The linear bearings at McMaster look really interesting, I'll have to spend
some time digging around in that stuff.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20190607/73e46ae6/attachment.htm>

More information about the Synth-diy mailing list