[sdiy] AS3280 test
james patchell
patchell at cox.net
Sun Nov 11 03:49:42 CET 2018
That is fantastic and welcome new.
Thanks Ian
-Jim
Ian Fritz wrote:
> Hello --
>
> Good news! Alex sent me a couple of his AS3280 chips, and they work
> great!
>
> I didn't do extensive testing, just a couple of measurements in my
> usual test configuration, which is a standard VCA circuit. I
> benchmarked them against a CA3280 that had previously been selected
> for high performance, and against typical results for older devices.
>
> Configuration: The input diode pins are fed a 1 mA current. The input
> to the control pin is 0 - 0.5 mA, and the output current is the same.
> The I-V converter output is 0 - 2V.
>
> With the offset nulled at full gain, the variation in output voltage
> with Iabc is under 1 mV. My standard for a very good device is under 2
> mV.
>
> Output linearity vs Iabc was better than 1%, with two devices near
> 0.1% Devices I tested previously were mostly around 2%. So it
> shouldn't be too hard to select devices for critical multiplier
> applications.
>
> Thank you Alex!
>
> Ian
>
>
>
>
More information about the Synth-diy
mailing list