[sdiy] Solder stops flowing all of a sudden?

Karl Ekdahl elektrodwarf at yahoo.se
Wed Jan 22 01:36:59 CET 2014


i've used >30 rolls of this solder over the last course of 4 years :) it's just fine. i'm just trying to figure out why this is happening all of a sudden




Den tisdag, 21 januari 2014 18:32 skrev Barry Klein <Barry.L.Klein at wdc.com>:
A lot of the "no clean" "lead free" solders make bad looking joints after heated for more than a second or so.
Get some of this: http://www.mgchemicals.com/products/solder/fluxes/rosin-flux-835/
Put some in a plastic bottle or syringe with a needle dispenser to apply directly to the joint.
Some stores offer a flux pen which works too.

Barry


_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy




More information about the Synth-diy mailing list