[sdiy] OT: Fixing RME Fireface 800 power supply

Harry Bissell harrybissell at wowway.com
Tue Jul 3 19:44:43 CEST 2012


I'd bet that isn't a relay... its likely a X2 (film) capacitor intended for 'across the line' application (noise suppression)

H^) harry

----- Original Message -----
From: MrMcCrash <mrmccrash at gmail.com>
To: synth-diy at dropmix.xs4all.nl
Sent: Tue, 03 Jul 2012 13:17:00 -0400 (EDT)
Subject: Re: [sdiy] OT: Fixing RME Fireface 800 power supply

Am 03.07.2012 15:28, schrieb Gil W.:
> I got a dead FF800 which I'd like to repair. I used the PS unit from a working FF800 and the dead unit came alive, so obviously the PS is dead. Off circuit, no output voltages from the PS are seen. No burnt out parts, no shorts of transistors/diodes/diode bridge, looks clean. I noticed that in the dead PS unit, there's no "click" sound heard as you power the unit on... On the working unit, you will head a click sound a second after turning it on, but I don't see any relay in the PS, the click comes from what appears to be a transformer. 
> 
> I took parts from the working PS unit and places instead the one in the dead unit to see if I can find the defective part (RME doesn't let the schematic become available...). This way, I replaced all large transistors, the photocoupler, the UC3842 ic, coil and transformer. I also ran over all solder joints just in case there's a crack. So far no change except when I replaced the UC3842 which made the transformer make a high pitched noise when powering on and off (no click - and the working PS doesn't make that noise).

Did you check the Relay and its transistor and diode in the lower left?
It seems like it doesn't get activated and so the PSU won't run... (the
clicking sound)

> Before I'm going to look for a new one, any suggestions of what can be check further ? Thanks very much !
> 
> Here's how it looks like:
> 
> http://www.fileden.com/files/2009/5/8/2434738/2012-07-03_11-12-35_4371111111.jpg
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

-- 
Harry Bissell & Nora Abdullah 4eva



More information about the Synth-diy mailing list