[sdiy] Scope on a chip.
axisair at comcast.net
Wed Jun 1 21:12:11 CEST 2011
It works well for a general purpose monitor, freq counter, FFT monitor to
do a quick check to see if a module function is working.
I wouldn't use it for any hard core calibrations.
From: synth-diy-bounces at dropmix.xs4all.nl
[mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of Chris Muir
Sent: Wednesday, June 01, 2011 10:33 AM
To: s diy
Subject: Re: [sdiy] Scope on a chip.
I have one, and was considering making a module out of it, but was
disappointed in the refresh rate. It's too slow to be more than a toy, IMO.
A cute toy, though.
On Jun 1, 2011, at 9:33 AM, <grant at musictechnologiesgroup.com>
<grant at musictechnologiesgroup.com> wrote:
> Cute and tiny! And DIP! Did I mention DIP?
> "The Xprotolab is the first mixed signal oscilloscope with an
> arbitrary waveform generator in a DIP module. It measures only 1 x 1.6
> inches, and can be mounted directly on a breadboard. The Xprotolab can
> also be used as a development board for the AVR XMEGA microcontroller."
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
"Thar's only two possibilities: Thar is life out there in the universe which
is smarter than we are, or we're the most intelligent life in the universe.
Either way, it's a mighty sobering thought." - Walt Kelley (as Porky Pine)
Chris Muir - cbm at well.com
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
More information about the Synth-diy